The replica Breguet 7587 is a mechanical copy of Breguet's slim round dress watch, built to match the original's case size, guilloché dial texture, Breguet hands and Roman numerals. A good 1:1 version runs a Japanese or Swiss automatic movement inside a sapphire-topped steel case with gold plating, and it sells for roughly $180 to $900. Quartz versions exist at the bottom of the market and are the easiest to spot.
What Is the Breguet 7587?
The 7587 belongs to Breguet's classic round dress family, defined by a thin case, a fluted caseband, straight welded lugs and a hand-guilloché dial. Breguet's core design codes, including blued steel hands, an offset signature and Roman numerals, run through that family.
The genuine watch is cased in 18k gold and finished with hand-engraved dial work, which is why the case alone accounts for a large share of its retail price.
How Close Does a 1:1 Replica Breguet 7587 Get?
Case dimensions are the easiest part to copy. Good replica makers work from the original's specs, so diameter, thickness and lug width land within a fraction of a millimeter.
The dial is where most replicas give themselves away. Real guilloché is cut on a rose engine, while cheap copies stamp or print the pattern and the ridges look flat under a loupe.
Case material is the second tell. Most replicas use 316L stainless steel with gold plating or PVD, so the tone is warmer and the weight lighter than solid 18k gold.
Which Movement Should a Replica Breguet 7587 Use?
Three tiers exist: Miyota 9015 or Seiko NH35 automatics at the value end, ETA 2824 or Sellita SW200 clones in the middle, and decorated clone calibers with engraved bridges and blued screws at the top. A Miyota 9015 is the safer bet for daily wear because parts and service are easy to find.
Automatic movements beat quartz in every visible way. The seconds hand sweeps instead of ticking, the rotor spins when you move your wrist, and the caseback shows real gears.
What Should You Check Before Buying?
- Dial texture: crisp concentric ridges, no smeared or pixelated printing.
- Hands: deep blue-black heat-blued tone, not bright painted blue.
- Caseback engraving: sharp and deep, with readable reference and serial lines.
- Crown: signed, correctly sized and smooth when winding and setting.
- Strap: leather with alligator grain and a signed pin or deployant buckle.
- Movement photos: ask for a picture or short video with the caseback removed.
How Much Does a Replica Breguet 7587 Cost?
Entry replicas run $150 to $250 and usually hide a quartz or basic automatic movement. Mid-tier pieces cost $300 to $500 and add sapphire crystals, cleaner dial printing and Swiss-pattern automatics. Super clone 1:1 versions sit at $600 to $900 and are the only tier worth comparing side by side with the genuine watch.
Common Flaws to Watch For
- Case thickness more than 1 mm off the original spec.
- A flat printed dial instead of raised guilloché ridges.
- Bright blue hands with visible paint edges.
- Loud rotor noise or a seconds hand that stutters.
- Lume that glows green or too bright on a dress model.
Does a Replica Breguet 7587 Hold Value?
No. Replica watches have little resale value and no collector market, so treat the purchase as a wearing cost rather than an investment. Expect to lose most of what you pay if you resell.
How Should You Care for a Replica Breguet 7587?
Keep it away from water unless the caseback gasket has been tested, since dress watch seals are usually rated for splash resistance only. Wind or shake it before wear and have the movement serviced every four to six years. Store it on a soft surface away from magnets and direct sunlight.
Counterfeit sales are restricted in many countries and shipping rules vary, so check local law before ordering.